Assign additional Tasks to the same Maintenance Order
Explanation
This activity is used to assign additional pending
tasks to a maintenance order that has been released and for which work orders
have already been generated. You can assign tasks only for the same top serial (or a serial in its
structure) as the one currently on the maintenance order.
If additional tasks, including non routines and
condition measurement tasks, without connected operations are assigned, the task
will not be distributed automatically. Instead, it will be set to the
Incomplete status. Before the task can be set to the Under Preparation
status, a valid instruction (i.e., instruction for the part revision of the
serial defined on the task) must be connected to it. Note that it is necessary to set the
task to the Under Preparation status in order for it to be released and
distributed to a work order.
Prerequisites
- A maintenance order must exist.
- Pending tasks for the serial or for serials in its
structure must exist.
System Effects
- The task is distributed to the same workshop as
the rest of the order with the same planned start and finish dates and with
the same distribution type.
- The task(s) will be added to the maintenance order
and distributed to the work order if the distribution type is either Work
Order or Execution Logic Structure.
- If the distribution type is Execution Logic
Structure, tasks will be added to the ongoing maintenance order and
the connected operations will be mapped into the correct Execution Logic Orders (ELOs)
on the maintenance order. In addition, the operations will be mapped into
corresponding ELO work orders in IFS/Work Order Management.
Window
Maintenance Order
Related Window Descriptions
Maintenance Order
Maintenance Order/Assign Tasks
Maintenance Order/Assign
Tasks/Pending Tasks
Procedure
- Open the Maintenance Order window and query (F3) for the
necessary maintenance order.
- Click the Assign Tasks tab and then
click the Pending Tasks sub tab.
- Select the Include Task? check box for the
task you want assigned to the selected maintenance order.
- Save the information (F12).